• Shenyang Baoshan Woodworking Machinery

Home > News > Content
How To Solve The Song Straight Edge Banding Machine In The Use Of Some Problems And Failures
Jan 11, 2018

Curved linear edge banding machine's main advantage is the bonding firm, fast, lightweight, high efficiency, in order to great effect, in addition to the purchase of a good edge banding machine, but also pay attention to edge band, hot melt adhesive, substrate, Working environment and methods of operation and other elements. Edge band selection should pay attention to the width, thickness, material, toughness, surface treatment and other factors. Hot melt adhesive to pay attention to high, medium and low temperature plastic difference, and the type of edge band match, but also to set the temperature control of science and the temperature of the sol and the flow of solidification delay. Substrate selection also has quality, temperature, parallelism and verticality requirements, the working environment of the indoor temperature, dust concentration also need to consider the operation of the substrate, edge band, plastic shaft speed, pressure, balance, Consistency will affect the edge effect

Maintenance song straight edge banding machine method Curve edge banding machine in use there will be some problems and faults, common faults are: 1, electrical fault. Including the host stalls, warming up unhealthy, disorder procedures, etc., not ruled out in time, will burn out the motor and heating pipe, or even damage the entire mechanical system. Maintenance of the main check electrical control box, motor, heating pipe, delay and so on. This maintenance is generally to be repaired by a specialist or manufacturer. 2, gas fault. Including valve failure, leakage, low pressure, cutting knife, feeding does not work, the main check all kinds of pneumatic components in good condition, the replacement parts can be made under the guidance of the production technicians in the factory. 3, mechanical failure. The main transmission failure, uneven coating, feeding failure and cutting knife failure, the main check all the mechanical parts intact and solid parts, transmission parts are offset. 4, bonding failure. Such as sticky, deviation, entrainment, etc., which is a comprehensive failure, and plastic shaft, edge banding, sol, substrate and operation. Such failures may occur alternately or may occur singly, depending on the specific maintenance

Curve straight double-sided adhesive woodworking edge banding machine, drawing on the merits of manual edge banding machine at home and abroad, combined with many years of experience in manufacturing woodworking machinery, manual edge banding machine developed, not only easy to operate, but also reasonable structure. Suitable for all kinds of furniture edge banding.