• Shenyang Baoshan Woodworking Machinery

Home > News > Content
Selection Of Straight Line Edge Banding Machines To Pay Attention
Jul 03, 2017

The main advantage of straight-line Edge Banding Machines is the bonding firm, fast, lightweight, high efficiency, in order to take this effect in addition to the purchase of a good Edge Banding Machines, but also pay attention to Edge Banding Machines, hot melt adhesive, substrate, working environment And operating methods and other elements. Select the edge band to pay attention to the width, thickness, material, toughness, surface treatment and other factors. Hot melt adhesive should pay attention to the difference between high, medium and low temperature glue, and match the type of Edge Banding Machines, but also set the temperature control temperature and the flow of sol and coagulation delay. The selection of the substrate also has the quality, the temperature, the parallelism and the verticality of the cut surface. The indoor temperature and the dust concentration of the working environment also need to consider the speed, pressure and balance of the substrate, Consistency and so will affect the edge effect. Fourth, the maintenance of straight line edge of the machine method Straight line Edge Banding Machines in use there will be some problems and failures, common faults are:

1, electrical failure. Including the host to stop, warming up, program disorders, etc., not promptly ruled out, will burn the motor and heating pipe, or even damage the entire mechanical system. Maintenance of the main inspection electrical control box, motor, heating pipe, delay and so on. This maintenance is generally done by a professional or by a manufacturer's manufacturer.

2, air failure. Including the valve failure, leakage, low pressure, cutter, feed does not work, the main check a variety of pneumatic components of the integrity of the replacement parts can be produced under the guidance of technical staff.

3, mechanical failure. Mainly there are transmission failure uneven adhesive feeding failure and cutter failure, the main inspection of the mechanical parts of the intact and the location of the transmission parts of the fixed position.

4, bonding failure. Such as sticky, deviation, entrainment, etc., which is a comprehensive fault associated with the plastic shaft, edge band, sol, substrate and operation. This failure may occur alternately or may vary depending on the circumstances.